PE inspection chambers, one piece DN400 1in 1 out D200/160 H=1520

Description

Mounting instructions for inspection chambers:

1.The hole is bored at a depth equal to the assembly rate, plus approximately 15 cm; the width of the hole should take into account the compaction equipment/beetle to be used for the mounting;

2.An assembly bed is made up of a 15 cm well flattened sand layer;

3.The chamber file is cut at the height desired (minimum 0.8, freeze depth);

4.The connection hoses are prepared for connection, by cross-cutting on site, with a toothed saw, and chamfering in order not to damage the sleeve gasket where the connection hose will be placed;

5.The chamber is placed in the assembly hole;

6.The conduits are connected to the chamber;

7.The ditch is filled and compacted in consecutive layer of 25-30 cm each;

8.A square encasing with approximate dimensions of 750x750mm is buit around the cover.A concrete plate is cast inside the encasing.

NOTE! THE FREE SHIPPING OFFER DOES NOT APPLY TO THIS PRODUCT.